Epson RC170 Guia do Utilizador descarregar pdf (Página 285)

11. Remote Control

EPSON RC+ 5.0 (Ver.5.4) User's Guide Rev.4 267

For the details of the dialog setting, refer to the section 5.12.2 Controller (Setup menu) -

Setup: Controller: Setup.

Set the remote control available by the following procedure.

(1) Open RS-232C port that is connected from client equipment to the specified port in the

Remote RS232 of the Controller, using the communication parameter specified in the

RS-232C port setting.

(2) Send the remote start command (EOT).

(3) Specify the password set in the Remote RS232 to the parameter and send the Login

command.

(4) Client equipment has to wait until Auto (GetStatus command response) is ON, before

execution of remote command.

(5) Now remote command will be accepted.

Each command executes the function when the input acceptance condition is satisfied.

Program debug from EPSON RC+ 5.0 development environment is capable as follows.

(1) Build a program as usual.

(2) Open the Run window and Click the RS232 Enable button.

When you only acquire the value using the Remote RS232 control, the RS232 Enable

button is not displayed. Click the Start button of the device specified as the control

device.

(3) Now remote command will be accepted.

Brakepoint setting and output to the Run window is available.

After Login, if no command is send within the timeout duration of the RS-232C, the

timeout error will be returned. In this case, re-execute from sending remote start command.

If error occurs, execute the Reset command to clear the error condition before executing

the operation command. To clear the error condition from external equipment by

monitoring, use the “GetStatus” and “Reset” command.



NOTE

1 2 ... 280 281 282 283 284 285 286 287 288 289 290 ... 311 312

Sem comentários

Epson RC170 Guia do Utilizador Página 285