Epson RC170 Guia do Utilizador descarregar pdf (Página 275)

11. Remote Control

EPSON RC+ 5.0 (Ver.5.4) User's Guide Rev.4 257

11.10 Remote Ethernet

Remote Ethernet makes it possible to control the robot and controller from external

equipment by sending the remote commands through Ethernet (TCP/IP).

To set the remote Ethernet functions valid, follow the procedures below to configure the

parameter.

(1) Select Controller from the Setup Menu and select the Remote Ethernet page.

(2) Configure the necessary items for the remote Ethernet control.

(3) Click Apply to save the new setting and click Close.

For the details of the dialog setting, refer to the section 5.12.2 Controller (Setup menu) -

Setup: Controller: Remote.

Following setting for the control device is not necessary when you select “Use only for

monitoring”, and only acquire the value using the Remote Ethernet control.

Set the control device to “Remote Ethernet” by the following procedure.

(1) Select Controller from the Setup Menu and select Controller Configuration page.

Select “Remote Ethernet” in the [Controller device] box.

(2) Click Apply button to save the new settings, click Close.

For the details of the dialog setting, refer to the section 5.12.2 Controller (Setup menu) -

Setup: Controller: Setup.

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 311 312

Sem comentários

Epson RC170 Guia do Utilizador Página 275