Epson TM-T88II Series Manual de Instruções descarregar pdf (Página 31)

Rev. A Features and General Specifications 1-19

TM-T88 Series Technical Manual

Panel Button

Note:

The ESC c 5 command enables or disables the panel button. When disabled, the button will not

function.

DIP Switches

For the serial interface model

The DIP switches are located at the bottom of the case.

Feed (FEED) button: Non-locking push button

[Function] If you push this button once and release it, the printer

feeds paper for one line based on the line spacing set by

ESC 2 and ESC 3. If you hold down the button, the

printer will feed paper continuously.

Paper feeding using the FEED button cannot be

performed under the following conditions:

1. The paper roll end sensor detects a paper end

2. When the printer cover is open.

If you push this button when the printer is in the

macro execution standby state, the defined macro is

executed.

During self-test printing, you can stop the self test

temporarily by pressing this button and restart it by

pressing the button again.

DIP switch 1

DIP Switch Function ON OFF

1 Data reception error Ignored Prints “?”

2 Receive buffer capacity Data buffer 45 bytes Data buffer 4 KB

3 Handshaking XON/XOFF DTR/DSR

4 Data word length 7 bits 8 bits

5 Parity check Yes No

6 Parity selection Even Odd

Transmission speed selection

Refer to Transmission Speed Table

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 153 154

Sem comentários

Epson TM-T88II Series Manual de Instruções Página 31