
REV.-A
4.2.5.6 Removal of Carriage Motor (Figures 4-25 through 4-26)
1. Perform steps 1 to 5 of Section 4.2.5.5.
2. Disconnect the motor cable from the carriage motor. Disconnect the lead wire of
the home position
sensor from the molded clip at the bottom of the frame. (Refer to Figure 4/-25.)
3. Loosen the four tabs securing the carriage motor frame to the chassis frame, using
and remove the carriage motor frame.
i
+
—%
Tab
Tab
Fig. 4-25. Carriage Motor Frame Removal
4.
5.
a screwdriver,
Remove the belt tension spring from
ring on the carriage motor side, then
holder, belt pulley and timing belt.
the carriage motor frame. Remove the E type (3.2) retaining
remove the plain washer, belt pulley flange, belt pulley shaft
%3’”
Retaining Ring E type (3.2)
Plain Washer
e
&
Belt Pulley Frange
v
o
Belt Pulley Shaft Holder
Belt Pulley
\
\ \,
*&
&
Carriage Motor Frame
Q
Carriage
Motor
<x
*
Belt Tension
%
Spring
Fig. 4-26. Removal of Carriage Motor
Move the carriage motor in the direction shown by the arrow to remove it.
4-16
Comentários a estes Manuais