Epson LX-86TM Especificações descarregar pdf (Página 87)

REV.-A

3. Disconnect the cable from connector CN6 on the

ROCX

board.

4. Unlock the two notches of the paper guide by pushing them frontward from the back side of the

printer mechanism, and remove the paper guide.

Fig. 4-9. Printer Mechanism Rear View

ADJUSTMENT REQUIRED

If any problems occur (such as non-uniform print density) after removing and installing the platen

unit or replacing the platen unit with a new one, perform the following adjustment.

● 4.3.1 Platen Gap Adjustment

4.2.4.2 Removal of Printer Mechanism (Figure 4-10)

Remove the platen unit and the paper guide. (Refer to Section 4.2.4.1.)

Disconnect the cables from connectors CN5, CN4, and CN7 on the

ROCX

board. (Refer to Figure

4-5.)

Loosen the six tabs of the lower case, which secure the printer mechanism to the lower case, by

pushing them with a screwdriver. The printer mechanism can be removed easily using the following

procedure:

WARNING

When loosening the tabs, be sure to push them softly so as not damage the lower case or printer

mechanism.

Fig. 4-10 Printer Mechanism Removal

4-8

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 141 142

Sem comentários

Epson LX-86TM Especificações Página 87