Epson TM-U300PC Manual do Utilizador descarregar pdf (Página 7)

While pressing the paper feed switch for more than 10 seconds after the printer in turned on, the self

test mode is initiated.

The printer self test includes a listing of the current default settings, read and write test of internal RAM,

checksum test of internal program memory, loop back detection statement, a staggered dot line, a few

lines of rotating character set, and a diagnostic report.

The printer then enters into the On-Line mode.

Configuration Setup

When the paper FEED switch is pressed and released instantly as the power is applied to the printer, the

printer will print the current printer configuration settings along with the DIP switch information.

If the printer setup needs to be changed, turn the Power Off before changing the setting.

The printer will be setup at the factory as follows;

Printer is setup as follows:

Model : ODP300

Firmware : Ver X.XX

Interface : Serial

Emulation : Epson TM-U200

CR Character : CR=CR only

Flow Control : DTR/DSR

Data Bits : 8 Bits

Parity : None

Baud Rate : 9600

CPL : 40/33 Char/Line

Two Color : Installed

Auto Cutter : Installed

Journal : Installed

3. Self Test

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Sem comentários

Epson TM-U300PC Manual do Utilizador Página 7