Epson EPL-N2000 Guia do Utilizador descarregar pdf (Página 55)

5-4 Configuring the EPL-N2000 for UNIX

If the card responds, you are ready to print. If not, print a

status sheet and check the IP address to make sure that it

corresponds to the IP address entered in the /etc/hosts file.

If you used the IP address to test the connection, make sure

that you entered it correctly with ping.

Setting Up the EPL-N2000 as a Remote Printer

After you set up the EPL-N2000 as a network device, you need

to set it up as a remote printer. If your UNIX system has an

/etc/printcap file, continue with the procedure below. If not,

see “Setting Up the EPL-N2000 with Other UNIX Systems”

later in this chapter.

In addition to the host name assigned when you set up the

printer as a network device, you must enter a remote printer

name for the EPL-N2000 and a local printer name for the

printer whose output is being redirected.

Users who want to append a form feed to the end of a print file

or insert carriage returns at the end of lines must include

output filters when they send a print job. Before users can enter

filters with the lpr command, you must set up the EPL-N2000

to recognize these filters. You do this by specifying different

remote printer options when you edit the /etc/printcap file.

You must specify a different remote printer name and local

printer name for each remote printer option that you include—

in essence, treating the EPL-N2000 as if it were more than one

printer.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 90 91

Sem comentários

Epson EPL-N2000 Guia do Utilizador Página 55