Epson EPL-N2000 Guia do Utilizador descarregar pdf (Página 38)

3-2 Configuring the EPL-N2000 for AppleTalk

This chapter describes how to configure the EPL-N2000 from a

Macintosh computer using EPSON Net! for Macintosh.

Before configuring the EPL-N2000 on an AppleTalk network, do

the following:

❏ Install the optional EPSONScript Level 2 ROM module

(C832261). (See the instructions that came with your

module.)

❏ Install the EPSONScript driver for Macintosh. (Look for the

driver diskette in the box that the EPSONScript Level 2 ROM

module came in.)

❏ Make sure the EPL-N2000 is connected to the network. See

Chapter 1 for information on connecting the Ethernet

interface card.

EPSON Net! for Macintosh consists of two utilities: EPSON

Zoner and EPSON Namer. To set up the EPL-N2000 for an

AppleTalk network, you need to copy these two utilities to your

hard disk and rename the printer using EPSON Namer. If

necessary, you then assign a zone to the printer using EPSON

Zoner.

Note:

EPSON Zoner works only on an AppleTalk Phase II network.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 90 91

Sem comentários

Epson EPL-N2000 Guia do Utilizador Página 38