Epson ActionTower 3000 Guia do Utilizador descarregar pdf (Página 88)

Hold the connector on the ribbon cable so the red wire aligns

with pin 1 on the drive. Make sure the holes in the

connector fit over all the pins; then push in the connector.

Locate a power supply cable for each drive installed in the

rear internal bay. These cables lead from the power supply

and have multi-colored wires with a plastic

connector

the end. Align the notched comers of the power supply

connector with the drive’s power connector; then push in

the connector.

10. If you have finished installing or removing drives, replace

the computer’s cover (described in Chapter 3) and see page

4-21 for post-installation instructions.

4-18

Installing and Removing Drives

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 136 137

Sem comentários

Epson ActionTower 3000 Guia do Utilizador Página 88