Epson TM-U325D Guia do Utilizador descarregar pdf (Página 7)

Ethernet IV Product Guide Page 7 Revision: D 6/14/2005

2.2 LED Indicator

When the module comes up it will initially blink at a rapid rate – After that, there are 5

modes of blinking:

1. 3 Blinks per second means there is no Ethernet Cable connected.

2. 20 Blinks per second on module initialization unless 10base-T connection.

3. Solid ON means that there IS a LINK 10base-T (but no data).

4. 50ms blink for data.

5. Solid OFF means the unit is NOT functioning.

2.3 Dip Switch Settings

The E4 has 4 user accessible dipswitches (SW1) on the front panel of the module.

These switches allow different functions depending on the position of the switch.

DSW1 ON – Prints configuration report on power up OFF – Normal

DSW2 ON – Not Defined OFF – Not defined

DSW3 ON – Not Defined OFF – Not defined

DSW4 ON – Change device settings (IP Address, Gateway, Subnet mask,

DHCP enable/disable, Device name, Print port) via web interface, ARP/PING, or

configuration protocol or any future methods.

OFF – Lock settings

Figure – 3 – Component Locations

SW1

JP1

JP2

TP3

TP1

TP5

DS1

XT1

VR2

TP2

VR1

TP6

TP4

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Sem comentários

Epson TM-U325D Guia do Utilizador Página 7