Epson Subli-Print 4450 Informações Técnicas Página 1

Installing the Dye Sublimation Printing System Instructions for Epson Stylus Pro 4450 Printer Beta Maxi A2 Swing Away Heat Press

Identify the end of the cartridge with the ink nozzle. Insert the ink nozzle end into the correct slot on the printer. Repeat for the other cartrid

After approx 2 minutes, ink lever messages will appear on the LCD display. Raise or lower the ink lever as instructed until READY appears. This indic

Installing the Printer Driver on your PC Locate the CD shown on the left containing the printer driver. This CD was supplied with your printer. I

Important: You now need to follow the steps to install the ICC profile. The ICC profile ensures correct colour output on your print outs. Instruct

Installing the ICC Colour Profile Note: You may need someone from IT to give you Administrator rights to be able to install software. Important: Y

Configuring the Printer Driver on your PC 1. Click on Start 2. Click on Control Panel 3. Click on Printers and Faxes 4. Right click on the pri

10. Click on show all profiles and select the ICC profile ‘ArTainium UV+ 4450 RGB v1.2’ from the drop down list and click on OK. 11. Click on ‘S

These three settings you have just set up are used for printing from non ICC packages such as Word, Powerpoint etc or any packages that cannot use IC

Printing a Nozzle Check. 1. On the computer attached to the dye sublimation printer - Click on Start 2. Click on Control Panel 3. Click on Printe

Once the print has finished you should then look closely at the nozzle check print out and follow the on screen instructions. A good nozzle check sh

Index Page Contents 1 Contact Information 2 Unpacking and Preparing the Printer 3 Unpacking and Preparing the Printer continued 4 Unpacking the bulk

Performing a Head Clean. Note: Instructions may differ based on operating system or printer driver versions installed. Occasionally a printer will

Installing the Heat Press ** You will need assistance to complete this section. The press requires two people to remove it from the box ** Please r

Setting the Time & Temperature This operation should be completed with the press in the open position

IMPORTANT HEALTH & SAFETY NOTICES ► The press should be placed on a sturdy suitable stand. ► Power supply cord must be disconnected before cle

Thank You and Welcome Firstly, Thank you for purchasing your Dye Sublimation printing system from ISub (Education) Limited and we welcome you to the

Unpacking and Preparing the Printer Locate the printer box. Find the perforated flap that contains the documentation and remove it from the box. S

These parts are not required, but should be retained for future reference. Open the printer box. Locate the standard Epson ink cartridges. These a

Remove the roll paper belt. Remove the roll paper feed support Now remove the printer from the box. This requires two people. Caution: this print

Now remove the tape securing this card and open the lid of the printer. Follow the string secured to the card to locate the carriage fixing board a

Locate the paper feed tray and remove the plastic bag and protective wrapping. Remove the blue transit tapes and put the paper trays into position

Press here to open the ink cartridge door. Move the blue lever into the unlocked position. Open the 4 x ArTainium UV Sublimation ink cartridges