Epson M119D Manual do Operador descarregar pdf (Página 13)

Setting Up the Printer 1–5

Note:

Your printer comes with inch-type hexagonal lock screws installed.

If you plan to use an interface cable that requires millimeter-type

lock screws, replace the inch-type screws with the enclosed

millimeter-type screws by using a hex screwdriver (5 mm). To

distinguish the two types of screws, see the illustration below.

2. Connect the other end of the cable to the connector on your

computer.

The Model with Parallel Interface

1. Make sure the printer and the computer are turned off. Then

plug the cable into the connector on the printer, as shown.

Note:

Squeeze the wire clips on the printer together until they lock in

place on both sides of the connector.

2. Connect the other end of the cable to the connector on your

computer.

Notch (one or more lines)

Millimeter-type

Inch-type

200b-ops.book : 200bo1r2.fm Page 5 Monday, September 22, 1997 11:46 AM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Sem comentários

Epson M119D Manual do Operador Página 13