Epson EX-1000 Guia do Utilizador descarregar pdf (Página 58)

Select download/standard character set

cESC> % <n>

1Bh 25h <n>

Both

1 27

-30

The command above selects either the standard or downloaded character set, where

01> is a binary value (OOh or Olh) or an ASCII value (“0” or”1”). If cn> equals OOh

or “0”, the standard character set is selected. This is the default value at power-on.

If Olh or “1” has been selected, then the downloaded character set is selected.

Graphics

The following commands relate to the graphical capabilities of the printer (bit image

mode). All bit-image printing is carried out as raster graphics (ie data is accepted in

blocks, and then printed as adjacent lines of graphics one dot wide).

Select bit image mode

Both

<ESC>

On> cno>

al>

<do>

. . . ain>

1Bh 2Ah

.,. -ain>

27 42

. . . ain>

-an>

cnb

al>

<do>

On>

-do>

The command above selects one of the graphic modes available on the printer and

prints graphic data, where on> is a binary value representing the graphics mode (see

table below), and cnO> and al> are binary values (low byte first) giving the number

of graphic data bytes following (as represented by uio> . . . cdru). The actual

number of data bytes varies according to the graphic mode chosen. The number of

data bytes is equal to the number of graphic columns to be printed.

[Graphic print modes]

* Adjacent dots are not printable in this mode.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 117 118

Sem comentários

Epson EX-1000 Guia do Utilizador Página 58