Epson CW3S20A Manual do Utilizador descarregar pdf (Página 141)

Disconnect any internal cables that may be in the way. As you

do, make a note of their correct locations and orientations for

later reattachment. Unscrew the retaining screw for the slot

guard, and set it aside. Mount the expansion board into the

slot by gently sliding the board into the slot. If the board is

long enough to reach the card guide mounted on the front

panel support flange, slide the board down the center groove of

the guide.

Making sure the board is correctly aligned, carefully insert the

board’s edge contacts into the slot connector on the main

system unit’s motherboard. A gentle rocking motion is helpful

in getting the board started in the edge connector.

Once started, press the board into the motherboard connector

until it is seated completely. The tab at the bottom of the

mounting bracket should fit into the slot at the bottom rear of

the main system unit, and the bracket’s top flange should rest

directly on top of the rear panel support.

CORRECT

NO ELECTRICAL OR

PHYSICAL RESTRICTIONS

INCORRECT

PHYSICAL RESTRICTIONS

7-12 Expanding Your System

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 165 166

Sem comentários

Epson CW3S20A Manual do Utilizador Página 141