Epson EasyMP Network Projection Guia do Utilizador descarregar pdf (Página 37)

Using Multi-Screen Display

B Click Connect.

The image allocated to each projector is projected.

In a Windows environment, you cannot view the image being sent

to a virtual display on the computer. To adjust the image on the vir-

tual display, you must do so while viewing the projected image.

To perform mouse-based operations on the virtual display, move

the mouse pointer in the direction of the virtual display so that the

pointer appears on the virtual display.

C To end projection for multi-screen display, click Disconnect

on the toolbar.

In a Windows environment, if the virtual display driver has been enabled

so that the mouse pointer can be moved outside the limits of the screen,

there may be occasions when you lose track of the location of the pointer. If

you are not using a virtual display, clear the virtual display checkbox on the

Add-Remove EPSON Virtual Display screen so that the mouse pointer

moves back inside the screen's display area. To subsequently use

multi-display again, place a check mark against the required display under

Add-Remove EPSON Virtual Display.

To clear a check mark, see the following.

s "Enable the virtual display driver (Windows only)" p.30

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 54 55

Sem comentários

Epson EasyMP Network Projection Guia do Utilizador Página 37