Epson EMP-7800 Guia do Utilizador descarregar pdf (Página 99)

Projector Monitoring and Control using a NetworkProjector Monitoring and Control using a Network

Once the settings have been made, press the [Menu]

button to close the configuration menu.

Problem Reporting Using the Mail Notification

Function

If EMP NetworkManager has been used to make the settings for the mail

notification function, notification messages can be sent to a computer with

a preset e-mail address when a problem or warning occurs with a projector

connected to the network. This will notify the e-mail recipient that there is

a problem with the projector.

Check the following points before starting up EMP NetworkManager.

• EMP NetworkManager must be installed in the computer to be used for

monitoring and control. p.95

• The computer and the projector must be connected to the network.

p.96

SNMP Enter the IP address to use for notification of SNMP

traps. Two IP addresses can be set as notification

addresses: "Trap IP Address

1" and " Trap IP Address

2". If a notification cannot be sent to the IP address that

is set for "Trap IP Address 1", then it is sent to the IP

address that has been set for "Trap IP Address 2".

MAC

Address

Shows the MAC address for the projector.

Projector name The projector name is a unique name that is used to

distinguish the projector from other projectors on the

network. Use EMP NetworkManager to change the

projector name. p.99

TIP

Once the projector has been connected to the network, EMP

NetworkManager can be used to change the projector's network

settings. p.100

TIP

• Up to a maximum of three notification destinations (addresses) can

be recorded, and notification messages can be sent to all three

destinations at once.

• If a critical problem develops with a projector which causes it to

suddenly stop working, it may not be possible for the projector to

send a message notifying an operator of the problem.

• If "Standby Mode" in the projector's "Advanced1" menu is set to

"Network ON", monitoring can be carried out even when the

projector is in standby mode (when the power is off). p.87

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 150 151

Comentários a estes Manuais

Sem comentários

Epson EMP-7800 Guia do Utilizador Página 99

Comentários a estes Manuais

Manuais e produtos relacionados com Projetores Epson EMP-7800