Epson TM-C100 Manual do Utilizador descarregar pdf (Página 4)

English

CLEANING

When printing becomes faint, press and hold the switch for more than three seconds to start cleaning.

Note: Do not use the CLEANING switch unless there is a problem with print quality.

Installing or Replacing an Ink Cartridge

Note:

For notes on the ink cartridge usage, see the instruction manual for the ink cartridge.

There is one ink cartridge for the single color model and a different one for the four-color model. If the

printer model does not match the ink cartridge type, the printer will not operate.

When the INK LED flashes, it is almost time to change the ink cartridge. Change the cartridge as soon as it

is convenient. When the INK LED is on, the ink is out or an incorrect ink cartridge is inserted. You must

install a new ink cartridge or a correct ink cartridge.

1. Make sure the printer is on.

2. Open the printer cover using the tab. See illustration A.

3. Lift up the empty ink cartridge by using the tab. See illustration E.

CAUTION:

There are plastic projections that supply ink inside the ink cartridge compartment covered

with ink. Do not put your fingers inside; otherwise, your fingers may get dirty.

Do not apply excessive force to the projections. Otherwise they might be broken.

When removing an ink cartridge, be aware that the convex parts at the bottom of the ink

cartridge that supply ink to the printer are covered with ink; therefore, to keep your hands

clean do not touch them. Also be careful where you put the removed ink cartridge.

Note: Do not remove an ink cartridge unless you are replacing it.

4. Take a new ink cartridge out of its packaging and open the transparent plastic bag.

Note: If an ink cartridge that has been out of the transparent plastic bag for a long time is used,

printing quality might not be satisfactory.

5. Carefully insert a new ink cartridge from the top. Be sure the inserting direction is correct. See the

instruction label attached to the back of the printer cover.

6. Push the ink cartridge firmly but gently until it clicks into place.

7. Close the printer cover completely. (The INK LED will now be off.)

The POWER LED flashes for approximately 1 minute during the ink replacing sequence. When the

POWER LED quits flashing and stays on, the printer is ready for printing.

Note: Do not turn off the power while the POWER LED is flashing. This will waste ink because the

printer has to re-start the ink replacing sequence. Also be sure not to open the printer cover while the

POWER LED is flashing.

Initial Ink Charging

When the ink cartridge is installed for the first time, the printer takes approximately 1 minute for ink charging

(the POWER LED flashes). Be sure not to turn off the power until the POWER LED stops flashing and stays on.

Disposal of Used Cartridges

Dispose of used ink cartridges as industrial waste products. Obey the laws and regulations of your

country and district.

Cleaning

If printing becomes faint, press the CLEANING switch and hold it for more than 3 seconds. Print head

cleaning will start. The POWER LED flashes during cleaning. When the cleaning stops, the POWER LED

stays on.

Note: Cleaning is performed by drawing clogged substances through nozzles (in this operation, ink is

also drawn); therefore, do not use the CLEANING switch unless there is a print quality problem. Do not

turn off the power or open the printer cover while the POWER LED is flashing.

Ink Cartridge Life

To make your ink cartridges last as long as possible, follow these simple rules:

❏ Do not turn the printer on and off unnecessarily.

❏ Do not press the CLEANING switch unless there is a problem with print quality.

When Using Roll Paper

Attaching the Roll Paper Holder

1. Be sure that the printer power is turned off. If the power is turned on, turn it off.

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

Epson TM-C100 Manual do Utilizador Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir Epson TM-C100