Epson FX-980 Informações Técnicas

®9-Pin Dot Matrix PrinterQuick Reference GuideContentsLoading Continuous Paper Onto the Rear Push Tractor. . . . . . . . . . . . . . . . . . . . . . .

10Replacing the Ribbon CartridgeRemove the separator from the new ribbon cartridge and discard it. Then turn the ribbon-tightening knob in the directi

11Gently press down on the cartridge until both ends click into place.Lift the cartridge’s ribbon guide (¿) and insert it firmly over the metal pins b

12Slide the print head from side to side to make sure it moves smoothly.Replace the printer cover and then close the paper guide cover.11 12Replacing

13Clearing Paper JamsPress the Operate button to turn off the printer.If an ejected sheet of paper is stuck on the paper guide, remove it.Remove the p

14Clearing Paper JamsIf continuous paper is jammed inside the printer, tear off the supply at the perforation nearest the paper entry slot.Turn the kn

15Attach the paper guide base, if necessary.Replace the printer cover and then close the paper guide cover.Press the Operate button to turn on the pri

If Your Printer Stops Printing Unexpectedly... Check the printer’s control panel lights and follow the appropriate instructions below. For more inform

2Loading Continuous Paper Onto the Rear Push TractorOpen the paper guide cover and remove the paper guide base.Open both sprocket covers, and fit the

3Attach the paper guide base, then lift the center section of the paper guide up and lay it flat.Close the paper guide cover, and make sure the paper

4Loading Continuous Paper Onto the Front Push TractorOpen the front paper guide by pulling the tab in the center. Remove the guide by grasping both si

5Attach the front paper guide by inserting it into the slots on each side of the printer as shown.Close the front paper guide. Then set the paper rele

6Removing the Printed Document From the Push TractorMake sure the Tear Off/Bin lights are flashing. (You may need to press the Tear Off/Bin button.) T

7Removing Continuous Paper With LabelsMake sure that the printer is not printing. You may need to press the Pause button to pause the printer. (When t

8Press the Operate button to turn off the printer. The printer is off when the surface of the Operate button is even with the button protectors as sho

9 QIf the pull tractor is installed, you can replace the ribbon cartridge when the print head is not in the ribbon installation position.Replacing the