Epson FX-850+ Guia de Resolução de Problemas descarregar pdf (Página 7)

NEW FX-850/1050 DOT-MATRIX PRINTER

If you plan to use the IBM emulation mode, choose IBM Proprinter (if

you have an FX-850). IBM Proprinter XL (if you have an FX-1050). IBM

Graphics printer, or IBM printer, in that order of preference.

Note: If your application program does not list the FX-850 or FX-1050,

you may want to contact the software manufacturer to see if an

update is available.

Installation/Support Tips

Software

The type of printer installed on your system must be identified for

each software package. This is usually done through a setup

menu. If this printer is not listed in your program, look in the

printer User’s Manual for the next-best model selection.

DIP Switch Settings

The default setting will usually work for moat applications, but

they should be checked before using the printer. This will avoid

unexpected results.

Serial Operation

The FX-850/1050 will be able to receive serial data with the

addition of an Epson 81XX series interface option.

Cut-Sheet Feeder Operation

The

page length will have to be adjusted (shortened) to 61 liner

per page if your software does not properly support cut-sheet

paper. There will be lines from the first page printed at the top of

the second page if the page length is not set correctly.

Disabling the Buffer

An undocumented feature of the FX-850/1050 is the ability to

disable the buffer from the SelecType panel. To toggle the buffer

hold down the Load/Eject switch at power on. Two beeps

indicate that the 8K buffer is enabled, and one beep indicates that

the buffer is disabled. (Some spooler applications wont work

correctly unless the buffer is disabled.)

Information Reference List

Sem comentários

Epson FX-850+ Guia de Resolução de Problemas Página 7