Epson ActionLaser 1000 Guia de Configuração

EPSON® 1000/1500Setup Guide

Note:If you connect your printer to a serial or optional interface, you myneed to change some of the printer’s settings. See the SelecTypeINTERFACE op

8Setting up your softwareChoosing the printer emulationYour printer has several resident printer emulations: HPLaserJet III (3/P/Si), Epson LQ, Epson

If none of the above printers is listed, select any printer modelthat uses the HP Printer Command Language (PCL).For the GL/2 emulation on the ActionL

10 setup

MaintenanceReplacing the Imaging cartridgeThe imaging cartridge prints up to 6,000 pages depending uponthe complexity of your print jobs.If your print

2.Gently open the printer cover and remove the imagingcartridge by pulling it toward you.3.Dispose of the imaging cartridge with nonburnable items.eCA

5.Set the imaging cartridge on a clean, flat surface. Firmly gripthe tab on the left side of the imaging cartridge. Pull theclear seal all the way out

7.Next you reset the TONER setting. Three messages flash inrotation on the display:NEW CARTRIDGE?YES, PRESS RESETNO, PRESS CONTINUE.8.Press RESET to c

Feed or paper jamWhen the printer stops printing and the FE E D JAY orPAPER JAM message appears, follow these steps:1.Open the paper cover. Carefully

ContentsSetup1 Unpacking...12 Installing the imaging cartridge...13 Loading paper...44

This booklet is to help you set up your printer and begin printingquickly. It also gives you instructions for routine maintenance. If youneed detailed

Setup1Unpacking1.Remove the accessories and printer from the shippingcarton.2.Set the printer on a flat, stable surface.3. Take the packaging off the

2.While holding the imaging cartridge horizontally, gentlyshake it a few times to distribute the toner evenly.3. Set the imaging cartridge on a clean,

4.Insert the imaging cartridge into the printer by placing thepins on each side of the cartridge into the grooves inside theprinter. Slide it gently i

3Loading paper1.2.3.4.5.Fan a stack of letter-size paper and even up the edges.Open the paper cover located on the top front of the printer.Adjust the

4Attaching the power cord1.Make sure the power switch at the top right of the printer isturned off.2. Insert the power cord into the back of the print

6Connecting the printer to thecomputerYou can connect up to three computers (two for theActionLaser 1000) to your printer at the same time. If you are