Epson ActionPC 3000 Manual do Utilizador descarregar pdf (Página 86)

Connecting the Drive and Power Cables

If you are installing a diskette or tape drive, follow all the steps

below. If you are installing a hard disk drive, follow the

instructions on pages 4-9 through 4-12. Then go to step 5 below.

Note

If you have one hard disk drive installed in the bracket

below the diskette drive and will install and a second hard

disk drive in the external bay, you need to purchase a new

hard disk drive cable that can reach both drives.

If you are installing another type of drive, see the

documentation that came with it to connect the drive cable;

then go to step 3 below to connect the power supply cable.

Locate the diskette drive ribbon cable; the connector in the

middle is already connected to the system board.

If you are installing a drive with a card-edge connector, make

sure you align the key-way (the plastic divider) with the

gap in the drive connector, as shown below.

gap

key-way

Installing and Removing Drives 4-19

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 130 131

Sem comentários

Epson ActionPC 3000 Manual do Utilizador Página 86