Epson ActionPC 2000 Guia do Utilizador descarregar pdf (Página 80)

Connecting the Drive and Power Cables

To connect the drive to the computer, you need to connect both

the drive ribbon cable and a power supply cable. If you are

installing a hard disk drive, follow the instructions on pages 4-9

through 4-12. Then go to step 5. If you are installing a diskette

or tape drive, follow the steps below.

If you are installing a diskette drive, locate the diskette drive

ribbon cable. (The connector in the middle of the cable is

already connected to the system board.)

If you are installing a drive with a card-edge connector, make

sure you align the key-way (the plastic divider) with the

gap in the drive connector, as shown below.

Installing and Removing Drives

4-19

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 128 129

Sem comentários

Epson ActionPC 2000 Guia do Utilizador Página 80