Epson C82324* Manual de Serviço descarregar pdf (Página 128)

Adjustment

DFX-5000+

Servicw

Manual

the distance measured at the left side is greater than that measured at the right side, move

the parallelism adjust lever in the direction shown by the white arrow in Figure 4-9. If the

distance measured at the left side is less than that measured at the right side, move the lever in

the direction shown by the black arrow.

Note:

The carriage guide shaft moves as shown in Figure 4-8. For example, when the

parallelism adjust lever is moved in the direction of the black arrow, the distance between

the right side of the platen and printhead nose narrows a little bit.

/f’7f@Y~

CARRIAGE GUIDE SH

AFT

REAR

;

/“”

PARALLELISM ADJUSTMENT LEVER

.9.

~,”

(PS)

(M4x6)

‘=./

:~[r

,:~$,

GUIDE SHAFT

HOLDER LEVER (RIGHT)

““*

‘‘0

GUIDE SHAFT

HOLDING SPRING

‘“v

Jw\

(PS)

(M4x6)

CARR

IAGE

MOTOR HOLDER

CBS (0)

Screw

(M4x8)

Figure 4-9. Parallelism Adjust Lever Operation

Note:

The carnage guide shaft moves as shown in Figure 4-8. When the parallelism adjust lever

10.

11.

12.

is moved

direction of the black arrow, the distance between the right side of the

platen and print head

nose

narrows a

little

bit.

Repeat step 7 and 8 until

the

distance between the distance measured at the two positions is

less than 0.01

mm.(The

#F610 dial gauge matches the “1O” notches.)

When the distance is

thithin

the specified range, tighten the two screws securing the

parallelism adjust lever. Then measure the distances again, as described in step 8.

If the distance between the measured distances is

whithin the specified range, apply screw

lock to the two screws. (Refer to Section 6.2 for lubrication and adhesive application

instructions.)

4-6

Rev.D

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 185 186

Comentários a estes Manuais

Sem comentários

Epson C82324* Manual de Serviço Página 128

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Epson C82324*