Epson TM-H5000IIP Manual do Operador descarregar pdf (Página 24)

Setting Up the Printer 1-9

CAUTIONS:

When connecting or disconnecting the power supply from

the printer, make sure that the power supply is not plugged

into an electrical outlet. Otherwise you may damage the

power supply or the printer.

If the power supply’s rated voltage and your outlet’s voltage

do not match, contact your dealer for assistance. Do not

plug in the power cord. Otherwise you may damage the

power supply or the printer.

1. Make sure that the printer’s power switch is turned off, and the

power supply’s power cord is unplugged from the electrical

outlet.

2. Check the label on the power supply to make sure that the

voltage required by the power supply matches that of your

electrical outlet.

3. Plug in the power supply’s cable as shown below. Notice that

the flat side of the plug faces down.

Note:

To remove the DC cable connector, make sure that the power

supply’s power cord is unplugged; then grasp the connector at the

arrow and pull it straight out.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 100 101

Sem comentários

Epson TM-H5000IIP Manual do Operador Página 24