Epson ActionPC 6000 Guia do Utilizador descarregar pdf (Página 85)

Connecting the drive cable to the system board

Follow the steps below to connect the hard drive ribbon cable

to the system board, if it is not already connected.

1. Locate one of the hard disk drive ribbon cables that came

with your computer; it is a flat cable with a connector on

each end and an additional connector on the ribbon cable.

All the connectors on this cable look the same.

2. Locate the hard disk drive interface that you want to use on

the system board; see the illustration on page 4-6 to locate

the interfaces. Use the primary interface for your boot drive

and your second hard disk drive; use the secondary

interface if you are installing your third and fourth drives.

Installing and Removing Drives

5-9

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 143 144

Sem comentários

Epson ActionPC 6000 Guia do Utilizador Página 85